RINSE WATER CONTROLLER RM-33

Specifically designed for the electroplating/metal plating industry, using proven technology for efficient rinse water control.

RinseTek controller kit with wired conductivity sensor

Order code: RM-33

RM-33 control unit RM-33 sensor RM-33 valve assembly

The RinseTek RM-33 is a rinse water controller for the plating industry, providing a simple to install and low cost method of controlling rinse water usage. This approach has several advantages over manual rinse water control.

Electrodeless conductivity technology is used because of its inherent accuracy and stability, with the added advantage that there is minimal requirement for cleaning or maintenance of the sensor.

The RM-33 is a complete rinse water control system kit including everything required to control the rinse water in a single swill tank. The kit comes pre-wired and installation time has been reduced to a minimum.

A specially designed polypropylene encapsulated conductivity sensor is used to measure the concentration of chemical contamination in the rinse tank, and a rugged solenoid valve is used to regulate the flow of water.

The RinseTek allows the volume of rinse water used to be measured with an integrated digital flow meter.

The system uses low voltage (24V) power to operate the controller and solenoid valve, so that the maximum safety benefits can be gained from use in the plating environment.

PDF iconView user guide